Managing a Cradlepoint Router in NCM with No Active WAN Connection
Products Supported: Any Series 3 Product. Click here to identify your router.
Firmware Version: 5.3.0 and newer - for information on upgrading firmware, click here.
Firmware version 6.0 has been released and introduces a vastly improved GUI for all current Series 3 routers. Cradlepoint has created new Knowledge Base articles with updated screen shots and instructions for the new GUI layout. As a result, this article has received its final update. To view the version of this Knowledge Base article for Firmware 6.0 and Later please click here
It is possible to manage a Cradlepoint router through NetCloud Manager (NCM) with no active WAN connection, such as when it is used as a failover device or configured in WiFi Bridge mode on an existing network. With the default settings, the router requires an active WAN connection to connect to ECM or obtain the current date/time from an NTP Server. To instead use the LAN to connect to ECM, you must set the Cradlepoint to use the LAN Gateway feature.
Configuration Difficulty: Beginner
- Log into the device's administration pages.
- Go to System Settings > Administration
- Select the Router Services tab.
- Select Use LAN Gateway and input the LAN Gateway Address. (This is the LAN IP address of the router that the Cradlepoint is connected to.)
- The DNS server fields might not need to be changed: these match the static DNS values (set at Network Settings > DNS). You can leave the default values or set them manually here
Once Router Services has been configured to use a LAN gateway, the device can now be managed by ECM via the LAN. However, because the device still does not have an active WAN connection, ECM will report the IP Address for the WAN source of the network the Cradlepoint is connected through.
- Setting up a LAN gateway for router services can be used to save money when a Cradlepoint router is configured for 3G/4G failover behind another router. If your 3G/4G data plan is small/expensive, you can set router services to use the LAN connection (following the above steps) so that ECM doesn't use 3G/4G data unnecessarily.
- In addition to NCM, other “router services” also require a WAN connection by default but can be configured to use the LAN instead. For example, the above steps will enable a connection to an NTP (Network Time Protocol) server via the LAN.
Published Date: 7/14/17
This article not have what you need? Not find what you were looking for? Think this article can be improved? Please let us know at firstname.lastname@example.org.